5 Maintenance Checks Every Bike Owner Must Do

One of the best form of exercise (aside from walking) is going around town on a bicycle. Bicycles help in reducing body weight and strengthen the leg muscles of a person. Like any other car, a bicycle also needs TLC from its owner. Bicycle TLC requires regular check-ups on your bicycle as well as maintenance of its parts.

Here are 5 tips for maintaining your bicycle to a good condition.

1. Do Not Leave Your Bicycle Outside

The weather has a lot of effects on your bicycle. If the weather’s rainy, leaving a bicycle outside may cause rust to form at a faster rate due to the moisture. When the weather’s sunny, the bicycle seat is susceptible to wear at a much faster rate. Store your bicycles inside your home to avoid unnecessary repairs. It also keeps thieves away from it.

2. Replace Worn out Tires

A flat tire is a cyclist’s nightmare. It’s a hassle to be stranded in the middle of the road without a spare tire at hand. Before you leave, make sure to inspect your bicycle’s tire. Check for punctures and pressure of your tire and perform appropriate action to it. If the threads of the tire are so worn out, replace them immediately.

3. Inspect Your Brakes

One of the primary cause of bicycle accidents is a faulty brake. Make sure to always check if your brake is properly working. Check if the brake pads are shiny. If they are, rough them up using a sandpaper. Shiny brake pads will not be able to hold the wheel when you need to stop. The same thing goes for worn out brake pads. They become smooth due to wear, thus causing accidents when you least expect it.

4. Check Your Bicycle Link

The bicycle chain is responsible for propelling your bicycle forward. It’s important to have these in good condition so to prevent accidents. A poor bicycle link will cause dislodging of links while the bicycle is in use. ThIs cause cyclists to go out of balance. To have them in good condition, apply lubricants so that it’s easier for the links to move while pedalling.

5. Check or Replace Bearings

Bearings are important because they help reduce the friction in a bicycle. Bicycles tend to use ball-type bearings that are located at the front and rear hubs, bottom bracket, fork tube, pedals, and freewheel. Over time, you need to disassemble the bearings and take them out for cleaning.

Dirt and grease tend to wear out bicycle bearings, making them inefficient for your vehicle. A noise would erupt if the bearings are acting up; a sign that you need to get new bearings.

Press your ear on the seat of your bicycle to listen to your bicycle’s internal noises. If a noise rings in your ears, it’s a sign that your bearings are worn out. Spinning the bicycle’s components will allow you to hear them too.

For bottom bracket bearings, you need to shift the smallest sprocket and remove the chain to hear the noise better. This helps remove the unnecessary noises generated by the chain. For rear wheel bearings, it’s best to remove the chain in the freewheel. As for headset bearings, it’s much tricky. However, it’s very obvious if the headset bearings would need replacement if they’re worn out or if there’s a notch in the rotation if they’re pitted.

So that’s about it! If you need bicycle bearings for your bicycles, visit Bearings Direct today!

Source:

You might also like More from author